Audio plug-ins for music applications
        20
        Sep

        M-MAX Multiband Limiter

        Making music louder is simply not enough for modern styles. Red Rock Sound M-MAX Multiband Limiter not only provides incredible levels of loudness, but also balances the spectrum and adds character, and all this contributes to the overall level of sound quality.

        GLOBAL LIMITER SECTION

        • Threshold — sets the global limiting threshold as a reference threshold for the 4 bands. Once set, any signal that goes above the threshold is limited, and gain is automatically made up by the same factor, i.e., if Threshold is set to -3 dB, then automatic makeup gain will accordingly be 3 dB. Next to the Threshold fader is located on the Input Meter, allowing easy adjustment with reference to input signal. If you do not have enough input volume, use the Input Gain control before working with the limiter. To the right of the Input Meter is the Attenuation Meter that displays the overall (wideband) attenuation;
        • The Lookahead chooser affects how quickly Limiter will respond to peaks that require compression. Shorter Lookahead times allow for more compression, but with an increase in distortion — particularly in the bass;
        • Oversampling — running the internal limiting process at a sample rate that is two, three or four times higher than the host's sample rate;
        • Master Release — the Release knob adjusts how long it takes for Limiter to return to normal operation after the signal falls below the ceiling. With Softening enabled, Limiter analyzes the incoming signal and sets an appropriate release time automatically;
        • Softening — depends on your release settings and slightly increases the desired time value depending on the average gain reduction;
        • Clipper Mode — allows you to choose between from the most transparent but Hard clip, Medium, and to the Softest but saturated;
        • Ceiling fader sets maximum output level, scaling the output signal to reach the out ceiling value but not exceed it. If your incoming signal level has no peaks that are higher than the ceiling, Limiter will have no effect. Next to the Ceiling fader is located on the Output Meter.

        CROSSOVER SECTION

        Filter Mode:

        • LR4 — fourth order Linkwitz–Riley crossover is probably today's most commonly used type of audio crossover. It's constructed by cascading two 2nd-order Butterworth filters. Steepness is 24 dB/octave (80 dB/decade). The phase difference amounts to 360°, i.e. the two drives appear in phase, albeit with a full period time delay for the low-pass section;
        • LR8 — eighth order Linkwitz–Riley crossover have a very steep, 48 dB/octave (160 dB/decade) slope.

        Along the lower edge of the graphic display are 3 crossover displays (Low, Mid, High). These can be dragged to adjust the crossovers. The Crossover frequency adjustment controls:

        • Low;
        • Mid;
        • High.

        BAND CONTROLS

        • Gain — controls the total gain of each frequency band;
        • Priority — adjusts the relative limiting across the bands. Raising Priority applies less attenuation to the respective bands (in relation to other bands) while maintaining the same overall limiting; lowering Priority results in more attenuation, applied to the respective bands. It’s important to remember that Priority settings are RELATIVE between bands. This means that if all bands are set to the same non-zero priority, it has the same effect as setting all priorities to 0;
        • Release (per Bands) — sets the reference Release time for each band.

        GRAPHIC DISPLAY

        has the ability to control:

        • Gain of each frequency band (Click with the left mouse button and move up or down);
        • Crossover frequency (Shift + Click with the left mouse button and move right or left).

        BACK PANEL

        On the Back Panel are Stereo Inputs/Outputs, Sidechain Inputs and Attenuation CV Outputs for each Band.

        Contact

        CUSTOMER SUPPORT
        support@redrocksound.ru

        RACK EXTENSIONS DEVELOPMENT
        redevelopment@redrocksound.ru

        GENERAL INFORMATION
        info@redrocksound.ru

        POSTAL ADDRESS
        Red Rock Sound
        Uritskiy st. 61, Krasnoyarsk, Krasnoyarsk Krai, 660049, Russian Federation